An environmentally friendly, water-based gas turbine cleaner with lower foaming than other comparable products but a higher percentage of active cleaning ingredients. FYREWASH® F3 is also available in a special Rolls Royce formulation and an oil & gas formula which is CEFAS approved for offshore use.

At Rochem, we develop specialist products for gas turbine compressor cleaning and FYREWASH® F3 sets the standard for surfactant water-based cleaning chemicals. Like our whole range, it can be used for effective on-line and off-line cleaning with outstanding results.

Highly biodegradable while reliably effective, FYREWASH® F3 is non-hazardous and user-friendly.

It removes a wide range of foulants enabling you to run an efficient, productive system while meeting environmental targets.

Available as wipes
FYREWASH® F3 is supplied in liquid form or as lint-free wipes which are perfect for are ideal for hand cleaning of gas turbines blades and other gas turbine parts.

Rolls Royce formulation
This cleaning chemical is also available in a specific Rolls Royce formulation.

Low-foaming
It has a higher percentage of active cleaning ingredients but lower foaming than comparable products.

Safe
It is non-hazardous, safe to use, and chosen for compressor cleaning around the world at thousands of sites without reported incident.

Effective
Used on-line or off-line, it sets the standard for performance and cost effectiveness from a water-based chemical. This product is ideal for frequent on-line washing of any type of industrial, marine or aviation gas turbine to maintain in-service output and fuel efficiency.

Insured
We back FYREWASH® F3 and all of our cleaning chemicals with our unique high value liability insurance.

Properties of FYREWASH® F3

• APPEARANCE: Colourless.
• SHELF LIFE: 5 years.
• TYPICAL PROPERTIES: Density 1.00g/ml@ 20°C, PH 7 - 7.5 (20% in water).
• DILUTION: FYREWASH® F3 concentrate with four (4) parts of water into a stable solution.
• APPLICATION: FYREWASH® F3 can be used with any on-line or off-line injection system.
• WATER RINSE: When on-line washing, as with all our chemicals, it is best carry out a rinse flush with demineralised water. For off-line washing, rinse until the run-off is clear.
• ANTIFREEZE: If the temperature falls below +10°C, we recommend adding antifreeze. FYREWASH® F3 is compatible with Methanol, Propylene Glycol and Ethylene Glycol. Enquire about our superior freeze point depressant.